Tips and common problems of improving working efficiency of horizontal screw centrifuge
In order to better improve the working efficiency of horizontal screw centrifuge, under the condition of ensuring the safety factor, in the process of separating corrosion-resistant or low corrosion materials, it can relatively improve the speed ratio of horizontal centrifuge separation drum; It is necessary to enlarge the filtering area in the drum of horizontal screw centrifuge.
Horizontal screw centrifuge
1.For example, it can improve the filter liner, which can keep fine voids in the middle of the horizontal screw centrifuge drum and improve the permeability coefficient; The total cross-sectional area can be increased by increasing the V-shaped filter separator, and the time of material filtration and separation can be increased. If necessary, a small amount of multi meal dewatering method can be selected to reduce the amount of filtering material in each dewatering of horizontal screw centrifuge, so as to ensure the actual effect of heterogeneous separation;

2.And preparation is very important, separation of production and processing of viscous materials, in the processing technology allowed scope, should carry out the actual operation of cleaning this kind of preparation; According to the relativity of countermeasures, the separation capacity of horizontal screw centrifuge can be broadened by increasing the particle size of solid materials. Under the condition that the processing technology will not change, the promotion of coagulant, coagulant, coagulant and other drugs can be considered to improve the separation efficiency of horizontal screw centrifuge.
3.Because the rotating inertia force of horizontal screw centrifuge is large, the starting current is large and the delay time is long, so the electrical equipment and route should be able to install a large load; It is not necessary to exceed the specific speed ratio and solid-state relative density specified in the factory name plate or operating instructions of the horizontal screw centrifuge; Before starting, the engine cover should be tightened and the anchor bolts and the fixed anchor bolts of the drive belt cover should be tightened.